SPR characteristics curve and distribution of residual stress in self-piercing riveted joints of steel sheets
Loading...
Files
Date
2017-02-15
Journal Title
Journal ISSN
Volume Title
Publisher
Hindawi
Abstract
Neutron diffraction was used to describe the residual stress distributions in self-piercing riveted (SPR) joints. The sheet material displayed a compressive residual stress near the joint, and the stress gradually became tensile in the sheet material far away from the joint. The stress in the rivet leg was lower in the thick joint of the softer steel sheet than in the thin joint of the harder steel sheet. This lower magnitude was attributed to the lower force gradient during the rivet flaring stage of the SPR process curve. This study shows how the residual stress results may be related to the physical occurrences that happened during joining, using the characteristics curve. The study also shows that neutron diffraction technique enabled a crack in the rivet tip to be detected which was not apparent from a cross-section. © 2017 Rezwanul Haque et al. This is an open access article distributed under the Creative Commons Attribution License
Description
Keywords
Neutron diffraction, Residual stresses, Fasteners, Steels, Mechanical properties, Tensile properties
Citation
Haque, R., Wong, Y. C., Paradowska, A., Blacket, S., & Durandet, Y. (2017). SPR characteristics curve and distribution of residual stress in self-piercing riveted joints of steel sheets. Advances in Materials Science and Engineering, 2017, 5824171. doi:10.1155/2017/5824171