Measurement of residual stresses in titanium aerospace components formed via additive manufacturing

No Thumbnail Available
Date
2014-02
Journal Title
Journal ISSN
Volume Title
Publisher
Trans Tech Publications Ltd
Abstract
In the present study gas tungsten arc welding (GTAW) with automated wire addition was used to additively manufacture (AM) a representative thin-walled aerospace component from Ti-6Al-4V in a layer-wise manner. Residual strains, and hence stresses, were analysed quantitatively using neutron diffraction techniques on the KOWARI strain scanner at the OPAL research facility operated by the Australian Nuclear Science and Technology Organisation (ANSTO). Results showed that residual strains within such an AM sample could be measured with relative ease using the neutron diffraction method. Residual stress levels were found to be greatest in the longitudinal direction and concentrated at the interface between the base plate and deposited wall. Difficulties in measurement of lattice strains in some discrete locations were ascribed to the formation of the formation of localised texturing where α-Ti laths form in aligned colonies within prior β-Ti grain boundaries upon cooling. Observations of microstructure reveal basket-weave morphology typical of welds in Ti-6Al-4V. Microhardness measurements show a drop in hardness in the top region of the deposit, indicating a dependence on thermal cycling from sequential welds. © 2014, Trans Tech Publications.
Description
Keywords
Residual stresses, Welding, Neutron diffraction, Aerospace industry, ANSTO, Microstructure
Citation
Hoye, N., Li, H. J., Cuiuri, D., & Paradowska, A. M. (2014). Measurement of Residual Stresses in Titanium Aerospace Components Formed via Additive Manufacturing. Materials Science Forum, 777, 124-129. doi:10.4028/www.scientific.net/MSF.777.124
Collections