Browsing by Author "Mozer, AJ"

Now showing 1 - 2 of 2
  • No Thumbnail Available
    Item
    Flexible polymer X‑ray detectors with non-fullerene acceptors for enhanced stability: Toward printable tissue equivalent devices for medical applications
    (American Chemical Society (ACS), 2021-12-08) Large, MJ; Posar, JA; Mozer, AJ; Nattestad, A; Alnaghy, S; Carolan, M; Sellin, PJ; Davies, J; Pastuovic, Z; Lerch, MLF; Guatelli, S; Rosenfeld, AB; Griffith, MJ; Petasecca, M
    There is growing interest in the development of novel materials and devices capable of ionizing radiation detection for medical applications. Organic semiconductors are promising candidates to meet the demands of modern detectors, such as low manufacturing costs, mechanical flexibility, and a response to radiation equivalent to human tissue. However, organic semiconductors have typically been employed in applications that convert low energy photons into high current densities, for example, solar cells and LEDs, and thus existing design rules must be re-explored for ionizing radiation detection where high energy photons are converted into typically much lower current densities. In this work, we report the optoelectronic and X-ray dosimetric response of a tissue equivalent organic photodetector fabricated with solution-based inks prepared from polymer donor poly(3-hexylthiophene) (P3HT) blended with either a non-fullerene acceptor (5Z,5′Z)-5,5′-((7,7′-(4,4,9,9-tetraoctyl-4,9-dihydro-s-indaceno[1,2-b:5,6-b′]dithiophene-2,7-diyl)bis(benzo[c][1,2,5]thiadiazole-7,4-diyl))bis(methanylylidene))bis(3-ethyl-2-thioxothiazolidin-4-one) (o-IDTBR) or a fullerene acceptor, [6,6]-phenyl-C61-butyric acid methyl ester (PCBM). Indirect detection of X-rays was achieved via coupling of organic photodiodes with a plastic scintillator. Both detectors displayed an excellent response linearity with dose, with sensitivities to 6 MV photons of 263.4 ± 0.6 and 114.2 ± 0.7 pC/cGy recorded for P3HT:PCBM and P3HT:o-IDTBR detectors, respectively. Both detectors also exhibited a fast temporal response, able to resolve individual 3.6 μs pulses from the linear accelerator. Energy dependence measurements highlighted that the photodetectors were highly tissue equivalent, though an under-response in devices compared to water by up to a factor of 2.3 was found for photon energies of 30-200 keV due to the response of the plastic scintillator. The P3HT:o-IDTBR device exhibited a higher stability to radiation, showing just an 18.4% reduction in performance when exposed to radiation doses of up to 10 kGy. The reported devices provide a successful demonstration of stable, printable, flexible, and tissue-equivalent radiation detectors with energy dependence similar to other scintillator-based detectors used in radiotherapy. © 2021 American Chemical Society.
  • No Thumbnail Available
    Item
    Significant performance improvement of porphyrin-sensitized TiO2 solar cells under white light illumination
    (American Chemical Society, 2011-01-13) Wagner, K; Griffith, MJ; James, M; Mozer, AJ; Wagner, P; Triani, G; Officer, DL; Wallace, GG
    A significant improvement in the photovoltaic performance of porphyrin-sensitized TiO2 solar cells under white light illumination is reported. The most significant improvement occurs within the first hour of light exposure and is irreversible within at least the studied 3-month period. Heat treatment in the dark produced only moderate performance improvement, whereas light treatment using a UV long-pass filter (>475 nm) led to an improvement similar to that obtained with the full simulated AM 1.5 spectrum, suggesting that the effect is linked to the photoexcitation of the porphyrin dye molecules. Light exposure resulted in simultaneous improvements in the short-circuit current (Jsc), the open-circuit voltage (Voc), and the fill factor (FF). The Jsc improvement is attributed to better charge injection demonstrated by thin-film APCE measurements. Photovoltage decay measurements showed a factor of 2−3 increase in the electron lifetime after light exposure, accompanied by a comparable decrease in the electron diffusion coefficient. The improved electron lifetime combined with the increased Jsc resulted in increased electron densities under open-circuit conditions, leading to improved Voc. Electrochemical impedance measurements showed a reduced charge-transfer resistance for I3− reduction at the Pt counter electrode, which is thought to be responsible for the increased filling factor. Furthermore, ATR-FTIR and X-ray reflectometry measurements indicated no significant change in the dye layer morphology after light exposure. An alternative mechanism involving the photogeneration of electronic states within the band gap of TiO2 leading to improved injection, slower electron transport, and improved electron lifetime is discussed. © 2011, American Chemical Society